How To Install Attic Ladder Springs

Insert one hooked end of a new ladder spring into the mounting bracket.

How to install attic ladder springs.

How to repair an attic ladder spring step 1. How to replace the springs on pull down attic stairs. Climb up into the attic. Do this by removing the screws from the ladder side first and then folding the spring back so that it is level and not about to snap down.

Next connect the opposite end into its hole in the connector arm with the point of the hook facing away from the ladder. Shut the attic door once you and your partner are in the attic. Use the same procedure to connect the cable from the drum on the other side of the stair. Pull down the stairs and switch on the attic light.

A step by step process to remove the old attic ladder and install a new one. One person will need to go into the attic and have the door closed. Faq for wood folding attic ladders. The springs are most relaxed when the attic ladder is in the stowed position.

Make the most of all of that space in your roof with an attic ladder. Hook the cable end onto the holder. For reattaching the springs on your model ladder you will need two people. Loosen the lock nut at one turnbuckle that connects a.

Extend the ladder fully and drill for the feet. Whether you already have an existing cavity in your roof or need to create a new one t. Once they are in overhead space and the person below is holding the ladder closed the springs will be able to carefully be removed. The foot gets attached with a bolt and lock nut.

Reach up to one of the spring drums grab the cable closest to the header and carefully pull it out. Inspect the brackets at the door hinge where the. We ll show you how to cut out frame the opening then install a fo. To finish your project get some spray foam and insulate the gap between the joists and the ladder frame.

Mark the holes on each side drill em out and attach the feet with the provided bolts and lock nuts. Pull the cable across the small pulley and down to the cable holder mounted to the door. If you are replacing the attic stairs unscrew the springs. How to install an attic ladder.

Clean around the area where the new spring will be fitted and then bring up the new spring. Then unscrew the spring on the attic floor joist. If an attic light is not installed carry a flashlight into the attic. This is from the werner ladder co.

Installing a pull down attic ladder is essential for safer easier access to your attic.