How To Install Aluminum Siding Starter Strip

This will help control water flow and prevent leakage.

How to install aluminum siding starter strip.

They need to run in the opposite direction of the metal siding. Make sure you install the furring strips horizontally and not vertically. Make a measurement using the tape measure allowing for the width of the corner post plus an additional 1 4 inch from the corner. Your first piece will lock into the starter strip at its bottom edge the top of the first piece has a nailing band that should be held down with aluminum roofing siding nails.

Now you can install a 3 8 x 1 inch starter strip of siding to give the first course the proper angle. Install your starter strip drip edge at the bottom of the wall and allow it to extend past the area where the foundation meets the sill plate by at least an inch. When installing the starter strips allow a 1 8 inch space for corner posts and j channels for expansion. Then nail them to the surface you re working on leaving 16 inches 41 cm between each strip.

This video shows how to install a starter strip for vinyl and polymer siding installation. Attach the siding to the wall with a nail in each section of the nail strip. Build with us. When installing the trim at the windows start at the bottom then move to the sides and install the top portion last.

When installing up against the roof edge make sure to leave 2 between the siding and the roof and paint the exposed edge using matching aluminum flashing between in the open space between the roof and siding to ensure a continuous seamless look more on this to come. Proper installation of of the everlast starter strip is critical. Install each course following your pencil marks while checking for level along the way. Be sure to place nails inch from the top edge of the lap siding to help keep your siding tight to the wall.

To install the furring strips start by cutting them to size so they run from one end of the surface to the other. Each sheet of siding has a nail strip at the top. Place the top edge of the starter strip along the chalk line. Nail in the center of the nailing slots.

How to properly install siding starter strips. Keep ends of adjoining starter strips at least 1 4 inch apart to allow for expansion. Position the end of a starter strip at this point.