How To Get Rid Of Mold And Mildew In Attic

Fans in the bathrooms are there to suck the moist air out after a shower.

How to get rid of mold and mildew in attic.

They are supposed to push this air through a vent pipe to the outside of the house. Need for attic mold removal. Bleach is corrosive and nasty to use and it kills only surface mold. The epa and other government agencies no longer recommend bleach for doing this.

The following getting rid of mold cleanup methods are recommended by epa and all of them can be applied in the attic assuming that it is a small area up to 10 sq. Removing attic mold yourself diy fix the moisture problems only but leave the attic mold behind. Regular cleaning products will leave behind enough mold for it to easily grow back. Install a bathroom fan or at least open a window to exhaust moisture.

You can also add a little dish soap to the bleach mixture to help the bleach penetrate porous surfaces such as grout. When the area is dry prime it with an alcohol based white pigmented shellac such as zinsser bullseye and use a paint containing mildewcide. Professionals have the proper equipment to protect themselves and your home or business from not only the mold but the chemicals they use to clean it. In addition to fixing the moisture problem that caused the mold problem you also need to get rid of the mold properly.

Step 1 thoroughly clean your attic. Apply the cleaner to any mold laden areas of your attic then use your sponge to vigorously wipe the infected areas clean. Nearly all types of mold can cause health problems so if there is mold in your attic you need to get rid of it. Begin learning how to get rid of mildew by scrubbing the area with a 1 2 percent bleach solution.

Get rid of mold contaminated surfaces by using a wet vacuum the type you can fill its tank partially with water to contain mold residue from the contaminated surface. Most attic mold can be purged with nothing more than a sponge and a commercial mold cleaner. Removing attic mold can be costly time consuming and troublesome and since it s in the attic where few people will see it you might be tempted to just leave it alone. Pay special attention to bathroom fans.

When adding soap to the mixture be sure to rinse after application. To do so there are three options. First of all scrubbing mold with ordinary cleaners won t make it go away. Mix 1 cup of chlorine bleach and 1 gallon of water in a bucket and carry the solution to your attic.

A bleach solution also works to kill mold. Many times the fan is never connected to a vent pipe and simply discharges this moist air into the attic. 5 dip a cloth or a soft brush into the solution and scrub the mold from all surfaces in your. Mix one cup of bleach in a gallon of water apply to the surface and don t rinse.