How To Fix Pitted Sheet Metal

Fast etch eats into the rust dissolving it and leaving clean metal behind.

How to fix pitted sheet metal.

Wipe the sanding dust off the metal with a rag. Grind down heavily rusted metal spots faster with a wire wheel and a drill or angle grinder. Sand the area again with a fine grit sand paper to. The sand paper can be held in your hand for smaller.

Scrub the metal with a wire brush to remove rust particles from inside the pits and wipe off the particles with a. If the area is heavily rusted and pitted and wire brushing by hand is ineffective use a drill with a wire wheel photo 2 and a primer that adheres to rusted surfaces such as krylon rust tough or rust oleum. Grind lightly over the pitted area of the metal. The cleanest metal in town.

Wrap a sheet of 80 grit sandpaper around a sanding block and sand the pitted area aggressively. Cover the area with plastic wrap to prevent the fast etch from evaporating before it can work. Sand the area with a coarse grit sand paper using a circular motion. Power brush the rusted areas with the wire brush on the power drill to remove the loose rust and flakes from the sheet.

In order to properly treat fill and prep the fender just follow these easy steps. Apply eastwood fast etch to the area with the rust pits. Be careful not to push down too hard.