How To Fit Roof Truss Clips

Nail each hurricane strap to your truss or rafter with 16 penny framing nails when you install hurricane straps to a roof.

How to fit roof truss clips.

This space needs to be pointing forward into the house for the clip to work effectively. Using a speed square square the marks across the wall plate and place an x on the marks. In such situation framing anchors or truss clips should be used. Enjoy the videos and music you love upload original content and share it all with friends family and the world on youtube.

Pull the tape measure along the length of your roof and climb up the ladder in the new position to take your measurement. Place the bottom of the truss onto the wall plate aligning the left edge of the truss with the edge marks placed on the wall plate for alignment. This can be done by skew nailing on all form of roof but on trusses or trussed rafters there is a danger of skew nails disturbing the joint or themselves being deflected by the plates or connectors resulting in an ineffective joint. Learn how a 6 timberlok can replace hurricane ties while meeting irc 2012 national code requirements for rafter or truss to top plate connections.

Climb a ladder near the corner of your roof and tape the end of your tape measure against the rafter using duct tape. This ensures that your trusses or rafters won t move during the installation of your straps. Position the clip so the gap in it is pointing forward into the house. The clips have a space where the wooden beam can sit in it.

Get off of your ladder and reposition it at the other end of your roof.