Lay the sheet on a flat surface and using a yardstick and a permanent marker or a grease marker measure and draw the line you wish to cut.
How to cut sheet of glass.
Measure measure and measure.
Use the head of the glass cutter to elevate the glass.
A wet saw is a motorized saw with a diamond blade that is used to cut.
Thoroughly clean the glass you intent to cut.
Score the glass with a glass cutter using a.
Work in an area.
Avoid working over carpet because of the risk of getting glass shards on the floor if the glass breaks.
To compensate for the offset subtract 1 8 inch from the desired measurement.
For example to cut a 10 inch wide piece of glass measure 9 7 8 inches and then make a mark.
For practice i would recommend 3 or 4 mm thick glass which is not hard to work with but also.
Using a wet saw 1.
Heat the wire until it s red hot.
Fill the saw s tray with water.
Start by resting the wheel of the cutter just off of the glass on the far side of the sheet then draw it toward you while applying consistent downward pressure as you pull the cutter across the surface.
For their own safety keep pets and.
Rent or buy a wet saw at a hardware store.
Lay the glass on a clean flat layered surface.
Next hold the yardstick to the marked line and run.
First score the glass on one side and press your thumbs firmly on the unscored side until you hear the etched side snap.
Use a framing square.
Getting ready for the cut.
How to cut glass step 1.
Make sure your wire is longer than the cut with the ends shaped into loops.
If it doesn t break through completely to the other side apply more pressure and lightly twist your hands to.
Firmly hold the material on both sides of the cut.
Set up your work area.
How to cut safety glass.
Put wood through the loops and tighten to use as handles.
Using a power saw to cut into thick glass is very dangerous without the aid of water.
Start with a clean dry piece of glass and use a sharp tool to lightly score the line you want to cut.
Measure the glass to the required dimensions.
You ll need a large flat surface preferably one that is slightly soft and won t scratch your glass.
A lot of jobs i ve done are down to the millimeter so.