How To Build An Awning Off A Shed

Fasten the nailer to the side of your existing building where you will attach the upper end of your rafters.

How to build an awning off a shed.

The end of the header should set back from the edge of the existing building by 1 2 inch plus the thickness of any siding and trim that will be added. To attach a wooden nailer to a metal sided building use a self drilling screw with sufficient threads to hold the nailer tightly. Use 2x6 lumber for the joists. Feb 11 2016 how to build a shed free videos 7 95 shed plans.

Using 2 80lb bags of ready mix concrete for footings i dropped a few shovels full in each hole except for the shallow hole. One hole could not go any deeper than a foot due to large rocks and tree roots. Mark the location of one end of the header and then mark the other end. To hang the awning measure and use a level to figure out the top placement.

After laying out a string on pegs in the shape of the shed i dug post holes by hand approximately 3 feet deep. Cut interlocking pieces of 18 inch corrugated metal to size and put it aside. First step is to locate and install the support header on the existing building. Retractable awnings provide instant shade or quickly roll up when you don t need them.

Make sure the lines are straight. Cut a straight line down the fabric at your mark horizonally. For example if you re building a 12 by 16 feet 3 7 m 4 9 m shed cut each of your joists to 16 feet 4 9 m. Once your fabric is trimmed stapled it face up onto the scrap of wood.

You don t have to take them down no storage hassles. Attach vertical screens to the extended awning to block the sun when its low in the sky. They don t require you to build a permanent structure on the deck. Cut the joists to the intended width of your shed.

Joists are the cross beams that will lie on the ground and hold together the outer framing of the floor. If possible nail through the siding into the building s framing members.