Was programed and working fine before today.
Genie 3055 garage door starts to open then stops.
Press and hold the wall console button until the garage door is completey closed.
If your garage door opens and suddenly stops it might be because of your logic board.
Check the bottom of the door.
You may need to give the cord a slight yank to reconnect.
If it still reverses raise the door halfway and stop it.
You should now be able to operate the door using the genie garage door opener.
They need to have a clear line of sight between them in order for the door to work properly.
Garage door only travels a little way and then reverses does your garage door only travel a little way 6 inches or so and then reverse.
Pull emergency release cord and knob toward the motor.
Door starts down then stops before it is closed.
When the opener is activated the screw rotates causing the nut to move until it reaches the switch.
Trolley on garage door opener hits stop bolt and clicks 10 times.
Open up the case and look for a screw type track that moves when the opener runs.
Safety sensors are the electronic eyes near the base of the door track on both sides.
The logic board receives and responds signals to any remote.
First you should check the safety sensors.
Check for interference from adjacent photo eye sensors of any brand.
Then look to see if the rollers are in working order.
Verify if there isn t a block between them.
When you push the button to open the door it sometimes doesn t start.
Try to keep the cord as parallel to the rail of the garage door opener as possible.
You might need to consider replacing it if your door is not working properly or you may purchase a new opener.
If you re genie excelerator just stops when either trying to open or close your garage door check out this video.
Check garage door for binding.
Genie garage door only moves a few feet and stops and when you push the button again it moves a few inches or a answered by a verified home improvement expert.