Garage Door Tensioner Adjusting

Retest the door balance as you did in step 1.

Garage door tensioner adjusting.

If your garage door cable is at an angle or l. To open the door completely adjust garage door opener by turning the limit counterclockwise. The torsion spring helps the garage door open and close easily. The springs are located at the top inside part of the garage door.

A problem with the spring tension could cause the door to open or close unevenly improperly or at the wrong speed and adjusting the springs will likely solve the problem. Adjust the springs on both sides of the door the same way. Step 1 adjust the limit. The limit the force and the safety reverse.

If it was opening too quickly move it to the next lower hole. You must release the tension on the garage door springs before attempting adjustment or replacement. Open it just as wide as you can without hitting the garage door opener s stop bolt and place a clamp on the track on both sides to keep the door in. If the garage door isn t opening or closing properly then check the tension on the torsion springs for needed adjustments.

You need proper tension on a garage door to operate the door by hand or with an automatic opener. If the tension is too loose the springs that help lift the. Garage door springs offset the weight of the door and allow it to open and close with ease. Adjusting an extension spring door.

How to adjust garage door tension. With an extension spring door the goal is to take all the tension off the door before you even think about touching a spring you can do this by opening the door all the way and propping it up with a ladder. This video will show you how to repair a mis aligned garage door cable. Hold the garage door in this position by attaching a c clamp to the track at a point below the lowest door roller wheel.

When your garage door opener isn t working properly there are several components you can adjust to address the issue. It s also important to remember that when you go to tighten the shaft only tighten until all the slack is gone from the cable. Once the spring is free of tension remove from its track hanger. If the door was closing too quickly move the spring to the next higher hole on the bracket.

This is accomplished by opening the garage door as fully as possible until it hits the stop bolt on the track. Turn the adjustment screw on the limit clockwise if the door doesn t fully close.