The entire apparatus mounts on the header wall above the garage door and has three supports.
Garage door stationary cone.
If you grip the bolt threads you will probably strip the threads and have to make a trip to the hardware store to get new bolts.
Start with the stationary cone.
A center bearing plate with a steel or nylon bearing and two end bearing plates at both ends.
28 july 2015 categories.
Commercial garage door operators.
Take the nuts and bolts from the spring anchor bracket.
Articles if you are replacing a broken torsion spring on your garage door then you have an option to order a new spring with winding and stationary cones already attached.
Drums cones cable accessories.
Many garage door owners inquire about the proper way to replace the cones at each end of the door s torsion springs.
How to safely remove cones from a garage door torsion spring.
However in most cases the existing cones are in perfectly good condition and can be used again with a new spring.
Weatherseal lubricants misc.
The winding cone is located at one end of the spring.
First install the bolts and nuts from the spring anchor bracket in the stationary cone and finger tighten them as pictured here.
A stationary cone is at the opposite end.
Next grip both nuts in a vise.
This can be a difficult and challenging.
Is a garage door repair company a life sustaining.